Changes

From Fellrnr.com, Running tips
Jump to: navigation, search

Lumo Run

351 bytes added, 22:19, 19 November 2016
no edit summary
Lumo Run is a [[Running Sensors| Running Sensor]] that mounts on the rear waistband of your shorts. It measures a number of aspects of your [[Running Form]], including [[Cadence]], Vertical Osculation (bounce), breaking, pelvic drop, and pelvic twist. Lumo uses a 9-axis sensor, which is a 3-axis accelerometer plus a 3-axis gyroscope and a 3-axis magnetometer allowing it to sense movement far better than sensors that rely on the accelerometer alone. It's this 9-axis sensor that allows some of the potentially interesting metrics to be gathered.
* '''Cadence'''. I believe [[Cadence]] is the single most important running metric, and while Lumo seems accurate, the lack of real time data is especially annoying here.
* '''Vertical Oscillation'''. This is how much your torso moves up and down with each stride. It is generally believed that less Vertical Oscillation is a better, but I suspect that this is an oversimplification. Some are part of a runner's vertical movement is likely to be elastic in nature (consider a bouncing rubber ball), some of the vertical motion will be while the runner is airborne (ballistic), and some of the vertical motion is the deceleration as the runner lands. So it seems likely to me that excessive vertical oscillation is bad, but it's a tricky to know what excessive is likely to be, or how to correct it. The measure of Vertical Oscillation (which Lumo terms "bounce") is similar to other devices and I will perform some verification using an objective measure in the future. Lumo recommend less than 3"/7.6cm of bounce.
* '''Breaking'''. Lumo measures how much your torso slows up on each stride, and recommends that it should be under 1.65 feet/second. I'll be curious to see how this compares to [[RunScribe]]'s foot breaking and [[Wahoo TICKR Run]]'s smoothness. (I'm not sure why this is measured as a velocity rather than acceleration.)
* '''Drop'''. As you run, your side of your pelvis that is supported by your leg tends to move up and the other side down. This pelvic drop might be a waste of energy, so Lumo recommends it should be under 12 degrees.
I think that the Lumo has potential, but needs more development.
* Other than Cadence which is more easily and effectively gathered using cheaper technology, there's not much evidence that any of the other metrics are valuable to a runner. While reducing "breaking" may seem intuitively a good thing, I'd like to see some research to back this up.
* Unfortunately, you not only have to run with your smartphone for The Lumo to work, but there's app has no display of any of the data in real time, not even Cadence. However, you don't have to run with your phone as the app will synchronize with the sensor when you finished. I've found the detection of when you start and stop your runs without the phone seems to work reasonably well.* The measure of Vertical Oscillation (which Lumo terms "bounce") is similar to other devices and I will perform some verification using an objective measure in the future. Lumo recommend less than 3"/7.6cm of bounce. * You have to wait until after your run to get summary data, and there are no graphs of how the metrics changed over the course of the run though you can see the metrics for each split. The split is 1 mile for metric runs with the phone and 5 minutes for runs without the phone, which is not very granular. * There are some audio "coaching" messages, but I found those both annoying and useless. These audio messages are no substitute for real time data. * There's no option to export the data for analysis or importing into other tools. There's also no web interface, so you can only view your data on your mobile phone.
* There's no "treadmill mode"; you can use it on a treadmill, but GPS is still used on your phone, which is less than ideal.
=Gallery=

Navigation menu